<div dir="ltr"><div><div><div>Hi Angelo,<br><br></div>Here's a handy diagram that shows which ones are which (found on Google Images):<br><a href="http://cholla.mmto.org/computers/beagle/hardware/pinout1-1024x585.png">http://cholla.mmto.org/computers/beagle/hardware/pinout1-1024x585.png</a><br><br></div>GPIO1_12 is connector P8 pin 12. I think I used the adjacent pin (P8 pin 11, or GPIO1_13) and installed a jumper wire between the two.<br></div><div>I think it says so in my comments too but I know that may not exactly jump out.<br><br></div>Steve<br><div><div><br><div><div><div class="gmail_extra"><br><div class="gmail_quote">On Sun, Jul 26, 2015 at 6:38 PM, Angelo Fraietta <span dir="ltr"><<a href="mailto:newsgroups@smartcontroller.com.au" target="_blank">newsgroups@smartcontroller.com.au</a>></span> wrote:<br><blockquote class="gmail_quote" style="margin:0 0 0 .8ex;border-left:1px #ccc solid;padding-left:1ex"><div dir="ltr">Greetings Steve, I have modified your code so the standard task only toggles one LED and the interrupt on GPIO12 should toggle the other 3. However, IO cannot for the life of me find which pin is GPIO12 so I can test on the hardware. I have posted the code with the mods I made at the bottom of this email<div><br></div><div><a href="http://beagleboard.org/support/bone101" target="_blank">http://beagleboard.org/support/bone101</a><br></div><div><br></div><div>What physical pin should I be toggling to make it work?</div><div><br></div><div>Thanks</div><div><br></div><br></div></blockquote></div></div></div></div></div></div></div>