<div dir="ltr">I wonder if having the sdcard in is affecting the eMMC, and thus those pins connected to it?</div><div class="gmail_extra"><br><div class="gmail_quote">On Wed, Jul 29, 2015 at 3:42 PM, Mr. Andrei Chichak <span dir="ltr"><<a href="mailto:groups@chichak.ca" target="_blank">groups@chichak.ca</a>></span> wrote:<br><blockquote class="gmail_quote" style="margin:0 0 0 .8ex;border-left:1px #ccc solid;padding-left:1ex"><div style="word-wrap:break-word"><br><div><span class=""><blockquote type="cite"><div>On 2015-July-28, at 23:31, Angelo Fraietta <<a href="mailto:newsgroups@smartcontroller.com.au" target="_blank">newsgroups@smartcontroller.com.au</a>> wrote:</div><br><div><div dir="ltr">I just tried writing to the pins using the methods in the interrupt example<div><br></div><div>What is very strange is that pin P9-15 toggles whether I write to GPIO1_16 or GPIO2_0, which may be why the read is not correct on it</div><div><br></div><div>So in short, </div><div><div style="font-size:12.8000001907349px">I found that GPIO1_0 to GPIO1_3 did not read or write</div><div style="font-size:12.8000001907349px">I found that GPIO1_30 and GPIO1_31 <span style="font-size:12.8000001907349px">did not read or write</span><br></div></div></div></div></blockquote><div><br></div></span><div>All routed to the eMMC chip U13. It is strange that GPIO1_4 through 7 work, perhaps the eMMC has been programmed in 4-bit mode.</div><span class=""><br><blockquote type="cite"><div><div dir="ltr"><div><div style="font-size:12.8000001907349px">I found that GPIO0_4 and GPIO0_5 <span style="font-size:12.8000001907349px">did not read or write</span></div></div><div style="font-size:12.8000001907349px"><span style="font-size:12.8000001907349px"><br></span></div></div></div></blockquote></span>Connected to I2C board id chip U7<span class=""><br><div><br></div><br><blockquote type="cite"><div><div dir="ltr"><div style="font-size:12.8000001907349px"><span style="font-size:12.8000001907349px">P9-15 writes whether writing to </span><span style="font-size:small">GPIO1_16 or GPIO2_0</span></div></div></div></blockquote><br></span></div><div>Yes, this makes sense. According to the schematics, 1_16 and 2_0 are wire-or-ed together with R160 and R161 and routed to P9-15.</div><span class="HOEnZb"><font color="#888888"><div><br></div><div><br></div>A</font></span></div></blockquote></div><br></div>