<p dir="ltr">Replying to the group <br>
On Feb 25, 2017 15:37, "Rehab Massoud" <<a href="mailto:rehab.massoud@gmail.com">rehab.massoud@gmail.com</a>> wrote:<br>
><br>
> I hope the answers below could be useful. <br>
> On Feb 25, 2017 14:58, "Scott Zemerick" <<a href="mailto:scott@zemericks.com">scott@zemericks.com</a>> wrote:<br>
> ><br>
> > I've been reading the forum posts over the last couple of days regarding the Zync Zedboard and Microzed.  Does anyone have any experience or suggestions on the following?<br>
> ><br>
> > * I have both the Zedboard and the ZC702 eval board - both of these use the same chip.  Anyone tried putting rtems on the ZC702?  I imagine that it would work since people have been successful with the microzed.  <br>
><br>
 I've managed to run a simple tasks with RTEMS on Leon3 on zedboadlrd, but didn't try with the processing system. <br>
> ><br>
> > * How is the I2C support in the rtems Zync Zedboard BSP?  Anyone using it with either the Zedboard or ZC702?  Example code to share?  What I2C slave device are you using?<br>
> <br>
As far as I know Zedboad doesn't support I2C. Xilinx development board supports it (as per its datasheet) if you need it.<br>
><br>
> ><br>
> > General thoughts/suggestions are appreciated!<br>
> ><br>
> > Thanks!<br>
> > Scott<br>
> ><br>
> ><br>
> ><br>
> >  <br>
> ><br>
> ><br>
> > _______________________________________________<br>
> > users mailing list<br>
> > <a href="mailto:users@rtems.org">users@rtems.org</a><br>
> > <a href="http://lists.rtems.org/mailman/listinfo/users">http://lists.rtems.org/mailman/listinfo/users</a><br>
</p>