[RTEMS Project] #3170: Microzed libtest/block08 fails to print end of test correctly.

[RTEMS trac]

#3170: Microzed libtest/block08 fails to print end of test correctly.
------------------------------+--------------------------
 Reporter:  Chris Johns       |       Owner:  Chris Johns
     Type:  defect            |      Status:  assigned
 Priority:  high              |   Milestone:  4.12.0
Component:  unspecified       |     Version:  4.12
 Severity:  critical          |  Resolution:
 Keywords:  zedboard testing  |
------------------------------+--------------------------

Comment (by Sebastian Huber):

 Replying to [comment:13 Chris Johns]:
 > Replying to [comment:10 Sebastian Huber]:
 > > Replying to [comment:9 Chris Johns]:
 > > > Replying to [comment:8 Sebastian Huber]:
 > > > > Replying to [comment:7 Chris Johns]:
 > > > > > I have always assumed the default configuration for '''any'''
 BSP lets the tests run. Is this not the case?
 > > > > No, this is not the case for the real hardware BSPs which usually
 use an interrupt driven console driver.
 > > >
 > > > This seems like a new requirement. Has something changed in RTEMS to
 cause this? I do not remember having this problem with previous versions.
 > >
 > > At least since I use RTEMS, this was the case.  I asked questions
 about this on the mailing list.
 >
 > The beaglebone black does not have the same problems as the Zynq. I
 checked the drivers for the BBB and there is an interrupt version so I
 wonder if the polled driver is used by default. I did not check this.

 It depends also on the hardware, FIFO depth, DMA support, etc.

--
Ticket URL: <http://devel.rtems.org/ticket/3170#comment:14>
RTEMS Project <http://www.rtems.org/>
RTEMS Project