Zynq BSP

[emanuel stiebler]

On 2014-07-18 09:39, Giovanni Macciocu wrote:
> Hi Emanuel,
>
> RTEMS has a BSP which is named xilinx_zynq_zedboard, I use the following configuration to build RTEMS for this BSP.
>
>   $ ../configure --target=arm-rtems4.11 --enable-rtemsbsp=xilinx_zynq_zedboard --prefix=/opt/rtems-4.11 --enable-posix --enable-networking

Hello Giovanni,
Yes, I noticed that. But I was hoping for a little write up, or how-to, 
on how to use it, or how is it intended to be used.
We still use the U-Boot to load it?

Cheers & thanks