Configure script enable-rtemsbsp flag

[Aurelio Remonda]

Hello, I was trying to build rtems for lm3s6965 bsp when i made a mistake on the
name of the bsp at --enable-rtemsbsp flag. Suprisely i did not get an error
Of course i did't get the well known 'make all' will build the
following BSPslm3s6965 either. Even later when i did make, no error
message popped up.
Is there a reason for not stopping the configure script and alert the
user about the error? In other words, should rtems configure script
notice the user made a mistake and prompt an error message?



-- 
Aurelio Remonda

Software Engineer

San Lorenzo 47, 3rd Floor, Office 5
Córdoba, Argentina
Phone: +54-351-4217888 / 4218211