rtems gdb patches

[Matthew J Fletcher]

>   

Hi,

I have tried to patch both gdb4.18 and gdb5.02 with the rtems diffs 
(snapshots/gdb-xx-diff), but both fail on configure.in and makefile.in, 
the code files seem to have been patched just fine.

I have used fresh virgin install (from the rtems site), of gdb both 
times, is this a known problem, or as anyone else had this problem.. ?

regards

---
Matthew J Fletcher
NPD Firmware
---



**********************************************************************
Serck Controls Ltd, Rowley Drive, Coventry, CV3 4FH, UK
Tel: 44 (0) 24 7630 5050   Fax: 44 (0) 24 7630 2437
Web: www.serck-controls.co.uk  Admin: post at serck-controls.co.uk
**********************************************************************
This email and any files transmitted with it are confidential and 
intended solely for the use of the individual or entity to whom they 
are addressed. If you have received this email in error please notify 
the above.  Any views or opinions presented are solely those of the 
author and do not necessarily represent those of Serck Controls Ltd. 
Please note that Serck Controls Ltd is able to, and reserves the right 
to, monitor e-mail communications passing through its network. 
This email has been checked for viruses.  Serck Controls Ltd shall not 
be responsible for damage caused by any undetected virus. 
**********************************************************************