PC-104

[Joel Sherrill]

Angelo Fraietta wrote:
> 
> I have been looking through all the emails in this thread an cannot seem
> to find which BSP you are using.

PC104 is just form factor for PCs so the pc386 and variants 
are the ones to use.  Post 4.5 snapshots include Chris Johns'
CS8900 libchip driver.

--joel

> rwas wrote:
> 
> > I'm using rtems with pc104. I am rather green on rtems however. I have
> > successfully compiled and run
> > two of the netdemos and hello world. My current problem is that rtems
> > won't use the serial port as the
> > console device.
> >
> > My processor board is the Jumptec MOPS/586..
> >
> > My main issues currently are getting or writing a device driver for
> > ethernet chipset (Crystal CS8900)
> > and drivers for a DtoA board as well as a Synchronous Serial Interface
> > board.
> >
> > Robert Wasierski
> > Dynacs Engineering
> >
> > Eric Norum wrote:
> >
> > > I apologize in advance if this is a FAQ, but is anyone out there in
> > > RTEMS-land using PC-104 SBC's?
> > > If so, with what processor?  Using what BSP?
> > > Thanks,
> > > --
> > > Eric Norum                                 eric.norum at usask.ca
> > > Department of Electrical Engineering       Phone: (306) 966-5394
> > > University of Saskatchewan                 FAX:   (306) 966-5407
> > > Saskatoon, Canada.
> >
> > _________________________________________________________
> > Do You Yahoo!?
> > Get your free @yahoo.com address at http://mail.yahoo.com
> 
> --
> Angelo Fraietta
> 
> PO Box 859
> Hamilton NSW 2303
> 
> Home Page
> 
> http://users.hunterlink.net.au/~maaaf/
> 
> There are those who seek knowledge for the sake of knowledge - that is
> CURIOSITY
> There are those who seek knowledge to be known by others - that is VANITY
> There are those who seek knowledge in order to serve - that is LOVE
>     Bernard of Clairvaux (1090 - 1153)