ARM EP9302 Board

[Ray]

Hi, Joel Sherrill  
(1) this board in not expensive
(2) Have enough interface for SBC
(3) I heard someone run RTEMS on EP93xx. And it can run linux/netbsd. So it would not be very hard to make a port for RTEMS.


     
Thanks & Best Regards!   
     
Ray, rayx.cn at gmail.com    
2008-01-08     


----- Receiving the following content -----     
From:  Joel Sherrill     
Receiver:  RTEMS Users     
Time: 2008-01-08, 01:31:41    
Subject: ARM EP9302 Board    



    
>Hi, 
> 
>I did some poking around during the holidays for cheap 
>boards that looked OK for RTEMS.  I found this for 
>USD179.95 with 16 MB Flash and 32MB RAM 
> 
>http://www.sparkfun.com/commerce/product_info.php?products_id=8208 
> 
>I see some users have had success with the EP9302 in the 
>past.  But I can't tell if this is something that should 
>work out of the box. 
> 
>Does this board look like it should work?  Does 
>anyone have experience with it? 
> 
>Advice, thoughts appreciated. 
> 
>--joe 
>_______________________________________________ 
>rtems-users mailing list 
>rtems-users at rtems.com 
>http://rtems.rtems.org/mailman/listinfo/rtems-users