Errors returned while building a SPARC tool set

[Aditya Upadhyay]

Hi Dannie,

Did you check the python version? It should be a development version.
First run this command:
sudo apt-get python2.7-dev

then try
../source-builder/sb-set-builder --log=1-sparc.txt
--prefix=$HOME/development/rtems config/5/rtems-sparc64.bset

Hope, It will solve your problem.

Regards,
aditya

On Thu, May 10, 2018 at 10:21 AM, Danxue Huang <danxue.huang at gmail.com> wrote:
> Hi folks,
>
> I just got a new laptop (Windows system) and I got stuck on building a SPARC
> tool set using Ubuntu in Virtual Box. To build a SPARC tool set, I use the
> command as below.
>
> ../source-builder/sb-set-builder --log=1-sparc.txt
> --prefix=$HOME/development/rtems config/5/rtems-sparc64.bset
>
> Is there anything wrong in it? After I input this command, it kept building
> for an hour but finally returned "Build FAILED", errors returned as below.
>
> error: building sparc-rtems5-gdb-8.0.1-x86_64-linux-gnu-1
>
> I also attached l-sparc.txt which is used to build a SPARC tool set, I would
> appreciate that if any of you can do me a favor to check it.
>
> Thank you so much!
>
> Best,
> Dannie
>
>
> _______________________________________________
> devel mailing list
> devel at rtems.org
> http://lists.rtems.org/mailman/listinfo/devel