sparc-rtems-gdb doesn't recognize target "sim"

[Shubham Bhagat]

Hello everyone,I've been trying to  run the hello world example in source tree to get started with sparc/erc32 but after building all that is required ( followed POSIX Compliance (Getting started challenge for RTEMS beginners)). Ifollowed all the commands. But, when gdb starts and I set "tar sim" it says: 

Undefined target command: "sim".  Try "help target".

I also tried running hello.exe from the testsuites sample using sparc-rtems5-run but it doesn't recognize the command.NOTE: The make and make install steps didn't finish with a "SUCCESS" or anything. They exited without showing any error.

Am I missing out anything here?


| 
| 
|  | 
POSIX Compliance (Getting started challenge for RTEMS beginners)

Ravindra Kumar Meena

POSIX stands for Portable Operating System Interface for uni-X. POSIX Compliance allows us to port the source co...
 |

 |

 |



-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.rtems.org/pipermail/devel/attachments/20191112/c84ed09d/attachment-0001.html>