Board Support Package for Excimer Board

[Joel Sherrill]

I thought someone else was working on this and that
this was a question better asked on the list.

--joel


Mohammad Rahman wrote:
> 
> Dear Sir,
>  I am a master student studing in a university in
> Germany. Right now I am working with    RTEMS. I have
> downloaded binutils, gcc, newlibs and rtems staffs and
> have installed those gcc stuffs successfully. I am
> using Motorola Excimer 603e PowerPC Board. I followed
> all the documents on your web side and inside into the
> RTEMS folder. But I did not find anything hint to find
> my target BSP for my Excimer board. So, just to know
> how to install RTEMS, I have used papirus BSP and that
> was ok.
>  So, right now I have to proceed on configure with the
> BSP of Excimer Board. But I do not find any sugguested
> way.
>  If you can help me from the very begining point of
> how to configure a new BSP just with hint, then I hope
> I can go on. I will be highly pleased and greatful if
> I get any good suggested way from your side.
>  Sincerely yours,
>  Mahfuzur Rahman.
>  Bonn, Germany.
> 
> __________________________________________________
> Do you Yahoo!?
> HotJobs - Search new jobs daily now
> http://hotjobs.yahoo.com/

-- 
Joel Sherrill, Ph.D.             Director of Research & Development
joel at OARcorp.com                 On-Line Applications Research
Ask me about RTEMS: a free RTOS  Huntsville AL 35805
Support Available                (256) 722-9985