gen68360 & termios

[sebastian ssmoller]

(...)
> > 
> > to enable ttyS1 ?
> 
> If the gen68360 BSP supported more serial ports, they would likely
> have been registered by  the console driver.  It only
> registers a single serial port.  Often a single serial port/console
> driver will register multiple serial ports if it can support them
> all.
> 
> AFAIK there is only a single serial port supported so there are
> no more device drivers in the gen68360.
> 

hhmm - ok - so in fact there are two hardware serial ports and the 68360
should support them both (afaik) ...

looking into console/console.c i found lots of code dealing with smc1
but none dealing with smc2 - so this meens to me two things: i am blind
XOR i cannot access ttyS2 with this driver ;-)

but console/console.c would be the right place to add this code right ?

(...)

back to the other prob:

> > 
> > any ideas while a simple tcgetattr & tcsetattr (without changing
> > anything ) causes my stdout to be broken ?

what about this - i thought just getting and (re)setting the attr's
would have no effect ... 

(...)

THX,
seb

-- 
"Perfection is achieved, not when there is nothing left to add, 
but when there is nothing left to take away."  
--- Antoine de St. Exupery, Wind, Sand, and Stars, 1939