rtems-hello-multiple baudrate problem

[Sebastian Huber]

On 2013-09-20 11:26, Sarkrass - wrote:
> We have compiled the rtems-hello-multiple.c example, with the RTEMS 4.10
> version, and succesfully upload it to the AT697 board installed in a RASTA 101
> system.
> The example sets the serial port baud rate to the default value (38400 bps);
> we tried to set the baud rate to any other value, the example is compiled
> without errors, but the modifications are not performed: the messages are
> received in the console to 38400 bps.
>
> Could anyone help us with this problem?

I would figure out if the console driver supports setting of attributes.  You 
can use a debugger to verify that you end up in the drivers set attributes 
function.

-- 
Sebastian Huber, embedded brains GmbH

Address : Dornierstr. 4, D-82178 Puchheim, Germany
Phone   : +49 89 189 47 41-16
Fax     : +49 89 189 47 41-09
E-Mail  : sebastian.huber at embedded-brains.de
PGP     : Public key available on request.

Diese Nachricht ist keine geschäftliche Mitteilung im Sinne des EHUG.