rwas mc68332 at yahoo.com
Fri Aug 17 23:57:42 UTC 2001

I'm using rtems with pc104. I am rather green on rtems however. I have
successfully compiled and run
two of the netdemos and hello world. My current problem is that rtems
won't use the serial port as the
console device.

My processor board is the Jumptec MOPS/586..

My main issues currently are getting or writing a device driver for
ethernet chipset (Crystal CS8900)
and drivers for a DtoA board as well as a Synchronous Serial Interface

Robert Wasierski
Dynacs Engineering

Eric Norum wrote:

> I apologize in advance if this is a FAQ, but is anyone out there in
> RTEMS-land using PC-104 SBC's?
> If so, with what processor?  Using what BSP?
> Thanks,
> --
> Eric Norum                                 eric.norum at usask.ca
> Department of Electrical Engineering       Phone: (306) 966-5394
> University of Saskatchewan                 FAX:   (306) 966-5407
> Saskatoon, Canada.

Do You Yahoo!?
Get your free @yahoo.com address at http://mail.yahoo.com

More information about the users mailing list