RTEMS on a softcore

[Mathew Benson]

Keep it on the mailing list.  That looks like a good one too.  All good suggestions.  So many options.  Ideally, I would like a single board capable of running RTEMS, with at least 128 MB of RAM, SD flash card, Ethernet or wifi, with 1 or 2 DAP's, an i2c pin, RS-232 interface, and with at least 6 hardware PWM GPIO pins.  I want to put this in my quadcopter.  I already have a micro controller driving the rotors and connected to the sensors, but rather than adding a CPU, I want to combine them in a single board.  One of my coworkers likes playing with FPGA's, so I said I would see if I could find an FPGA with soft core.

On Feb 11, 2013, at 6:43 AM, Jiri Freyvald <jiri.freyvald at gmail.com> wrote:

> Hi Mathew,
> 
> that's funny, I have the same thoughts.
> My goal is to port LEON3 on xilinx board, but i'll probably start with something like microblaze.
> Actually yesterday i ordered this board: 
> http://www.element14.com/community/blogs/alex-the-kidd/2013/02/06/pipistrello-rev-20-fpga-board
> (prize is $140)
> 
> So on some stage we could probably somehow exchange information.
> 
> With regards,
> Jiri Freyvald
> 
> 
> 
> 
> On 10/02/13 13:01, Mathew Benson wrote:
>> Has anybody got RTEMS to run on an inexpensive FPGA based board?  I'm looking at:
>> 
>> http://www.xilinx.com/products/boards-and-kits/AES-S6MB-LX9.htm 
>> 
>> Does anybody have a BSP for this?  Any inexpensive Altera boards?
>> 
>> 
>> _______________________________________________
>> rtems-users mailing list
>> rtems-users at rtems.org
>> http://www.rtems.org/mailman/listinfo/rtems-users
> 
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.rtems.org/pipermail/users/attachments/20130211/db9c75e7/attachment-0001.html>